Our lifters were developed by understanding haunt requirements and 15 years of experience. Two of our biggest concerns was storage and ease of setup. Our lifters accomplished both, and at a reasonable cost.
Storage is a just a matter of removing the pin from the base frame, disconnect the air lines from the cylinder and pulling up and out the upper lifter receiver. Instead of having a 3 foot by 2 1/2 foot prop, its now only 6" high and easy to store.
Setup only takes minutes; place upper receiver into the lower receiver frame, insert the quick release pin to secure receivers, attach airlines, power, and controller lines, affix prop, adjust air requirements, and prop is ready to use.
We offer three types of lifers: flat raiser, vertical lifter, and scissor extenders.
The flat lifter is great for casket and other props where you need the prop to lay flat and then pop up quickly to provide that perfect scare. This prop can lift props weighing up to 6-12lbs.
Our vertical lifter line comes in three configurations; small, medium, and heavy. All lift props into the air from behind the gravestone or other prop.
All of our lifters require air to run them. Your compressor should be able to supply PSI at 80 lbs. We recommend you not go beyond this.
Our scissor lifters come in two configurations, light and heavy. All extend the prop outward or inward.
As with all pneumatic props, your dealing with compressed air. Compressed air can accelerator your prop to speeds that will do major bodily harm or even be FATAL. EXTREME CAUTION WITH PLACEMENT, SETTING UP, ADJUSTING, SECURING THE PROP, AND SHOW ARE A MUST. ITS HIGHLY RECOMMEND YOU KEEP YOUR AUDIENCE AND OTHER STAFF MEMBERS AT LEAST 5' AWAY FROM THE PROPS MOST EXTENDED REACH. IF PROP IS DAMAGE DO NOT USE.